This should reset the control panel and restore function.
Ge refrigerator dispenser control board not working.
If the dispenser on a new refrigerator does not work.
After performing basic checks on the refrigerator power and use if the display still does not work try a basic reset.
Check for any burns on the circuit board.
There are many types and models of refrigerators.
3 dispenser control board faulty.
Any help on next steps would be appreciated.
In this case test each.
Other than the dispensor panel not working the refrigerator is working fine.
The general way to troubleshoot a refrigerator that has a blank display panel is to first try the reset methods above.
If it does not contact ge at 800 432 2737.
A ge refrigerator control panel that is not working may just need some troubleshooting to get the hardworking appliance back up and running.
If it does not you may have a bad display board bad main control board or have a wiring harness issue.
Refrigerator lock feature if the control board continues to be faulty or not work at all then it could be that the ge monogram refrigerator control lock was put in place by accident.
Replace the refrigerator door switch if found to be not working as designed.
The front dispenser panel still does not function.
Unplug the refrigerator and wait 30 seconds then plug it back in to the circuit.
That s where we come in.
The dispenser control board controls the water and ice and the display it can become faulty over time.
I replaced the control board and the interface dispenser asm with the parts noted below.
Here is a great video on the replacement of the ge refrigerator control board.
Static electricity caused by pulling away the plastic covering off the dispenser can cause it to temporarily lock up.
Refrigerator dispenser control panel not working.
The refrigerator and internal lights continued to function as normal.
Not only that you don t have time for that to happen to your fridge.
Of the dispenser components before testing the control board.
Inspect the board for signs of a short such as a popped capacitor or other issue.
If the entire dispenser system is not working the control board is more likely.
If only one dispenser part is not working it is probable that an individual part has failed.
The dispenser control board governs most of the functions of the dispenser system.
If you d like to verify that the clicking noise is actually coming from the control board then you can follow these instructions to take things apart plug it back in before removing the board then you can hear the clicking from the main controller board.